If so could you take a measurement for me? I would like to get one, but my space is tight. In the photos it appears that the units are one or two inches narrower around the edges, bottom and top. I am looking for the width of the base/footprint, which looks narrower than the overall width of 15.67 inches. If it it closer to 15 right at the bsse it should fit into my non-dometic slide.
Manwithavan
Joined
·
123 Posts
Outstanding! Thank you very much for the reply Brian. I think it should work. Now Dometic just needs to make more. Everyone is out of stock. How do you like it so far?
I have a "Tuff Stuff" slide. It is 29.25" by 15.75", but the usuable width is more like 15.25 because of small nylock nuts protruding inside the rail. I think I could just drop a piece of 1/2 or 3/4 inch plywood in the bottom to raise the base a bit and help avoid the nuts as well.
I have a "Tuff Stuff" slide. It is 29.25" by 15.75", but the usuable width is more like 15.25 because of small nylock nuts protruding inside the rail. I think I could just drop a piece of 1/2 or 3/4 inch plywood in the bottom to raise the base a bit and help avoid the nuts as well.
Joined
·
123 Posts
Awesome is right! I found one in stock at Northridge 4x4. I was suprised how little it draws down my 100ah AGM battery with 300W solar setup. The battery never drops below full charge in daylight, and overnight only dropped to 12.8V before quickly topping off in the morning. I was worried I might need another battery, but sure does not look like it. Super quiet too, which is a big reason I sprang for it.
![140131]( "140131")
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
