been considering putting polyiso on floor-
going to put full sheets down and Not cut it up to fit floor bumps-
no wood fillers -
Easier and maybe less squeaking chance -
Not sure if it should be glued down ??
I have no clue if polyiso will hold up to foot traffic
and not turn into dust or goo ??
one thing that I have considered is
so far i've spent a lot of time
walking around on stock ford flooring pad W black plastic
and so far my feet have not hurt at all-
worn several types of shoes from crocs to good boots -
all good
crawling around was not good tho -
have some cardboard pieces on floor to catch mess also -
Years ago when I worked in a grocery store they changed floor
matts from hard plastic to thicker softer matt and new mats Killed my feet-
after a week or so of use decided to just remove new matt and stood on cement floor-
in a month ALL the new mats were replaced with old matts again -
So I was thinking 1/2 of 3/4 polyiso insulation against metal floor
then stock floor pad grey-
then a 5mm thick plywood sheet
then stock ford black plastic flooring --
will double ish stock floor thickness -
have not messed with floor yet and stock floor pad may be stuck
to black plastic so layer plan may have to change -
Any thoughts on my plan ??
going to put full sheets down and Not cut it up to fit floor bumps-
no wood fillers -
Easier and maybe less squeaking chance -
Not sure if it should be glued down ??
I have no clue if polyiso will hold up to foot traffic
and not turn into dust or goo ??
one thing that I have considered is
so far i've spent a lot of time
walking around on stock ford flooring pad W black plastic
and so far my feet have not hurt at all-
worn several types of shoes from crocs to good boots -
all good
crawling around was not good tho -
have some cardboard pieces on floor to catch mess also -
Years ago when I worked in a grocery store they changed floor
matts from hard plastic to thicker softer matt and new mats Killed my feet-
after a week or so of use decided to just remove new matt and stood on cement floor-
in a month ALL the new mats were replaced with old matts again -
So I was thinking 1/2 of 3/4 polyiso insulation against metal floor
then stock floor pad grey-
then a 5mm thick plywood sheet
then stock ford black plastic flooring --
will double ish stock floor thickness -
have not messed with floor yet and stock floor pad may be stuck
to black plastic so layer plan may have to change -
Any thoughts on my plan ??
