The low roof van has a different profile than the others. I'd certainly purchase a flange for it.
Fantastic Fan, noise and installation
Hey y'all! I've been camper-converting a T-250, LWB extended high roof for a hot minute now and I'm getting close to done... got solar, wood floors, bed platform, insulation done... might document the build here sometime if people think it would be good information?
Anyway, one of my final tasks is to install a roof vent. I bought a Fantastic Vent and I have a couple of questions before I go sawing into my roof. One is that I hear some people complain about wind noise while driving... can anybody with experience discuss this issue with me? I'm pretty sensitive to driving noises and have worked tirelessly to hunt down squeaks and rattles. If after all of this my fan hollers 24/7 that is going to bum me out big time.
The second is, looks like they recommend flat mounting surfaces for this thing and the Transit roof is very conspicuously convex. Anybody have any issues with installation because of this? I had planned on doing the install with sheet metal screws and putty tape, maybe a wood frame on the underside for the screws to bite into.
Thanks in advance for any comments!
Anyway, one of my final tasks is to install a roof vent. I bought a Fantastic Vent and I have a couple of questions before I go sawing into my roof. One is that I hear some people complain about wind noise while driving... can anybody with experience discuss this issue with me? I'm pretty sensitive to driving noises and have worked tirelessly to hunt down squeaks and rattles. If after all of this my fan hollers 24/7 that is going to bum me out big time.
The second is, looks like they recommend flat mounting surfaces for this thing and the Transit roof is very conspicuously convex. Anybody have any issues with installation because of this? I had planned on doing the install with sheet metal screws and putty tape, maybe a wood frame on the underside for the screws to bite into.
Thanks in advance for any comments!
1 - 3 of 18 Posts
No. The center section is 9". The roof then drops 1/4" and then tapers up 3" to the roof level. I've had my roof fan for three months but haven't had the nerve to cut with this much to fill on the lower level.It looks like the center section where the vent goes might be the same.
Hein;
Have you had a chance to consider the low roof flange yet?
Joe
Have you had a chance to consider the low roof flange yet?
Joe
1 - 3 of 18 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Transit USA Forum
A forum community dedicated to Ford Transit owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, storage capacity, maintenance, and more!
Full Forum Listing
Recommended Communities
