[NW_Freedom]

Thanks....I was just looking at your website for the install. I had it saved from when you had issues. I got the kit from Heatso last year before I knew better. I'll find a spot to go up into the van away from the port. I'm wanting to get this all done before my floor is all the way in. Seems like lots of this could be cut down too. There is a ton of wire.

 

[NW_Freedom]

Or maybe just wrap it all up and shove it into the wall. I'm putting where you did but the other direction for the blower.

 

[JustAnotherUser]

So the Brown and teal color wire are my fuel pump wires right? Those connect into the piece that is in the bag and then into the fuel pump? Also, nobody shows any holes drill in the bottom for the wires to the fuel pump they just are showing intake/exhaust/Fuel l ine holes. You have to have one for the fuel pump power too right?

There's no need to drill an additional hole to facilitate the fuel pump power. That wiring harness allows for an enormous run so you can easily route the power connector out the back of the van via the rear pillar and out of one of the rubber hole covers.

 

[4Our]

Great Article! Thank you. any issues with the installed unit? carbon build up?

 

[Bazz99]

I believe that is the case. @Bazz99 helped her do it, IIRC, so same as his. There's a part-number / description for that size-down thing somewhere on here.

That said... it's just not that big of a deal to drop the tank and install the stand-pipe. I can't think of a good reason not to do that. 🤔

Hello,
I helped install another one a few months ago. A guy reached out to me and asked for some help. His is working great at high altitude too.

 

[gregoryx]

Hello,
I helped install another one a few months ago. A guy reached out to me and asked for some help. His is working great at high altitude too.

I'm going to help Nick do a diesel heater install shortly... going to be interesting to see if the tank install is easier than the drop-the-tank model... 😬

 

[Bazz99]

I'm going to help Nick do a diesel heater install shortly... going to be interesting to see if the tank install is easier than the drop-the-tank model... 😬

One mistake I made on the last one is the tank wasn't on EMPTY (light on!!), it had a 1/4 tank of gas and that was a lot more work reinstalling it!!