Ford Transit USA Forum banner
1 - 12 of 12 Posts

· Registered
Joined
·
243 Posts
Discussion Starter · #1 ·
I just received my 2016 Van. The vinyl floor covering in the rear is like a ski slope, stuff slides all over the place. I've PMed a few people about the bed rug, but they decided not to use it so I didn't get any opinions. I know some have used the coin stuff flooring but not sure of it's anti slip capabilities.
I'm open for any suggestions. My driveway is steep and right now I can get in the back of the van and just slide all the way to the front, not acceptable so looking for solutions regarding slippage. I've done the search button thing and not coming out with much results for slippage.
I'm not looking for something to completely stop stuff slipping (would be nice) but something has to be better then what Ford has to offer. My carpeting (E-series) offered better non-slippage then what's in it now.
Any help would be appreciated, thanks in advance.
 

· Registered
Joined
·
765 Posts
I put 5/8" horse stall mats in mine. Very heavy, but adds a little sound damping and they have little rubber nubs molded in.
JP

Sent from my SM-G900P using Tapatalk
 

· Registered
Joined
·
243 Posts
Discussion Starter · #9 ·
TRV- that's a Bedrug, did it help with the sliding issue that I'm having? Did you just pull the original vinyl out and replace it? Thanks to you and the other members for the info.
 

· Registered
Joined
·
16 Posts
no sliding

TRV- that's a Bedrug, did it help with the sliding issue that I'm having? Did you just pull the original vinyl out and replace it? Thanks to you and the other members for the info.
The sliding issue went away with this. I had to cut the original mat to fit into my trash can. I did it myself but moving the mat into the car takes a little bit of effort. It'll be easier with a helper just because the size of the mat.
Be careful when you order them to match your bed side.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top