Ford Transit USA Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter · #1 ·
Has anyone installed windows that cut the ribbing between the mid and rear panels?
This is a mockup - I've outlined in blue the ribbing between the mid and rear factory window cutouts.
Is this going to jeopardize the integrity of the van, or lead to noise and vibration issues?
View attachment 140128
 

·
Registered
2020 Transit 250 AWD HR Ecoboost camper
Joined
·
26 Posts
I put in a similar sized sliding window.i just cut through it all then used brutal tape on the inside to have a uniform thickness.i laid it out on the inside used a angle grinder with a cutting wheel from the inside making two short cuts on the top and one on each side,then went outside and traced the opening with a cardboard template ,put on masking tape to avoid scratching the paint and cut out with a jig saw
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top