Ford Transit USA Forum banner
1 - 20 of 20 Posts

· Registered
Joined
·
411 Posts
I got the same mats recently. But I cut the mat in half so that I can take out one side and empty it. Actual cut is closer to the driver side.
 

· Registered
Joined
·
411 Posts
Here is a picture of where I cut the mat:



The 4x4 shifter is to the right of the parking brake (this picture was taken before the mat was installed):

 

· Registered
Joined
·
134 Posts
Thanks a lot. Shifter in my Quigley is located on the driver side of the tunnel and I guess I can slightly modify the way you cut the mat to go around it.
below is a picture of Quigley prototype shifter.
I've got a Quigley, and the Husky mats... I'm cutting a 2" hole to pass through the knob today!
 

· Registered
Joined
·
134 Posts
I have the weathertech mats. I like them and they do the job. But if I were to buy them again I think I would go with the Husky's
I was a little surprised how thin and flexible the Husky mats were as compared to the VW Monster Mats and Nissan All Season mats I have in other vehicles.

On the plus size, they were easy enough to (have someone at work) cut out the hole!
 

· Registered
Joined
·
393 Posts
I didn't know the husky mats were on the thin side. I haven't seem them up close to compare. I'm sure either get the job done. I just wanted something to protect the floor and they do that well enough. They won't last forever so next time I'll research a little more.
 

· Registered
Joined
·
134 Posts
Looking at mats..... Husky has them carpet or vinyl. Weathertech says vinyl only, not suitable for carpet..... Kinda scratching my head over that one....
I think the bottoms of the Husky are different for carpet vs vinyl... I just got the vinyl ones.
 
1 - 20 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top